An old conveyor does not always need replacing. Sometimes a new belt and wear parts give it years more. Sometimes the frame has given out.
What we inspect first
We start with the chain: the rollers, the bushings and the side bars, and how much slop is in them. The chain and belt are wear parts. Then we look at the frame.
Signs a rebuild will do
The frame is straight, the rails are sound, and the wear is in the belt, chain, sprockets and wear strips. A frame that has not rotted or been hit can last a long, long time.
What ruins a frame
- Water. Pits that stay wet rust the frame from below.
- What you run. One plant ran aluminum cans for 20 years. The soda that collected in the pit ate the frame away.
- Impact. Loaders that drive off the end into the pit, or hit the side with a bucket.
When replacing makes more sense
New belts and parts are not cheap. Chain, rubber, steel and labor have all gone up.
Sometimes, when parts cost more than about 60 percent of a new machine, owners choose to replace instead.
Parts for any make
We sell bearings, belts, wear strips, sprockets, shafts and oilers for our conveyors, back to our earliest builds. We also build replacement belts and parts for other makers’ machines.
A replacement belt usually takes about three weeks to build and ship.
Rebuild or replace?
Send us photos of the chain, the belt and the frame. We will tell you what we see.