Pit and Incline Conveyors: Lengths and Layout

Equipment Solutions For The Recycling Industry

Most infeeds start below the floor and climb to the machine. The pit lets a loader, grapple or tipping floor feed the belt at ground level.

Who builds the pit

You or your concrete contractor build the pit. Most of the time, you tell us the pit and we build the conveyor to fit it.

How long a pit you need

It comes down to three things: your volume, the equipment you load with, and your space.

A low-volume plant with one skid steer pushing boxes may need only 10 feet. That keeps concrete cost and floor space down.

We have also built a 100 foot pit for a large paper plant. Three front-end loaders push material in at once, and each one needs 20 to 30 feet to work. A longer pit means loaders can push and go without being precise.

How deep a pit you need

We can work with almost any depth. A deeper pit just means taller legs.

The limit is on the shallow side. A heavy duty roller chain conveyor needs a pit at least 36 inches deep, ideally 40 inches or more. A slider bed can fit a much shallower pit.

Indoor and outdoor runs

Indoors, a conveyor lasts longer. Outdoors is harder on any machine.

On an outdoor roller chain conveyor, the oilers should run a lubricant that will not freeze.

Some conveyors start outside. One of ours runs 100 feet in the ground outside the building, then climbs once it is inside to feed another machine.

Angles and ceilings

A roller chain conveyor runs up to 45 degrees. Inclines run from 10 to 40 feet along the incline.

For steeper climbs, or material that rolls, we build a sidewall belt conveyor. Tall corrugated sidewalls and cleats form pockets that hold material on the climb.

Measure your ceiling early. Low ceilings are one of the most common limits we run into.

Planning a pit or an incline?

Send us your pit size, your ceiling height and the machine you feed. We will work out the layout.