Roller Chain Belt Conveyors

Product Description

Standard Roller Chain Belt Conveyors ship with two e-stop buttons and protective guards up to 8 feet above the ground. Conveyors use a shaft mounted, inverted rated motor and gear reducer. Conveyors are designed to run at a nominal speed of 40 FPM, unless otherwise noted. Conveyors include adjustable supports even if they are not visible on the preliminary drawing(s).


Tonnage Per Hour
Custom per application and requirements.
Factor of Safety
OSHA Compliant
Sizes
Custom Made Per Each Application
Lead Time
12-14 Weeks Depending on Current Workload
Frame
Open style frame for ease of maintenance. Jig welded for accuracy and cross braced for extra strength. All frames come with supports to floor with a 6 Inch nominal adjustment range.
Track
Track will be 30 lbs. A.S.C.E. Rail for both the drive track and the return track.
Skirting
1/2” plate side skirts the entire length of the conveyor with reinforcement every 30” along the lower horizontal and 60” along the incline and upper horizontal. Lower horizontal load depth will be 12” (304.8mm) and the upper horizontal will be 48” (1219.2mm) unless otherwise specified.
Chain
Chain is 9” pitch with 5” dia. flanged white iron wheels, 1/2” X 2 1/2” side bars, and 1” dia. heat treated pins with hardened bushings.
Belt
Belt constructed of 1/2" steel pans with 1/2" X 4” high overlapping side wings and 3" & 4" Angle Cleats on 48" Centers. The nominal belt speed to be 40 FPM.
Belt Support
Belt is supported by steel I-Beam topped with mild steel wear plates spaced no less than 21” across the width of the belt. Belt impact shoes welded onto every other pan.
Sprockets
Drive sprockets are flame cut hardened steel 6 tooth - 18” pitch diameter with timed keyways. Idler sprockets are flame cut hardened steel 6 tooth – 18” pitch diameter, one with a timed keyway and one with a regreaseable bronze bushing.
Drive
15.0 HP Gearmotor/ Reducer is TEFC high efficiency 230/460 volts, 3 Phase, & 60 Hz with a minimum 1.5 S.F. Comes with a torque arm and factory filled with oil.
Safety
Safety equipment includes: a set of backstops to prevent roll-back in case of power failure, side and bottom guarding up to 8’ (2438.4mm) from grade, and a one set (2) E-Stop push buttons.
Paint
Finish will be industrial enamel to minimum of 2.5 mils DFT, colored KWS Blue. Other colors available upon request.