Low Pro Drag Chain Belt Conveyors

Product Description

Standard conveyors ship with two e-stop buttons and protective guards up to 8 feet above the ground. Conveyors use a shaft mounted, inverted rated motor and gear reducer. Conveyors are designed to run at a nominal speed of 40 FPM, unless otherwise noted. Conveyors include adjustable supports even if they are not visible on the preliminary drawing(s).

Open style frame for ease of maintenance. Jig welded for accuracy and cross braced for extra strength. All frames come with supports to floor with a 6 Inch nominal adjustment range.
The Drive side will be composed of sheet metal decking with ½” Thick UHMW plastic strips for the drive track and ¼” thick formed angle for the return track with ½” thick UHMW plastic strips.
3/16” plate side skirts the entire length of the conveyor with reinforcement every 24” along the lower horizontal and 40” along the incline and upper horizontal. Lower horizontal load depth will be 12” and the upper horizontal will be 16” unless otherwise specified.
Chain is 3.075” pitch with ¼” X 1.25” side bars, and ¾” dia. heat treated pins with hardened bushings.
Belt constructed of 2 Ply Rubber with 3" Angle Cleats on 24.6" Centers. The nominal belt speed to be 40 FPM.
Belt Support
Belt is supported by steel sheet metal with ½” thick UHMW strips. UHMW strips will be spaced no less than 16” across the width of the belt.
Drive sprockets are flame cut hardened steel 8 tooth – 8.035” pitch with timed keyways. Idler sprockets are cast hardened steel 8 tooth – 8.035” pitch, one with a timed keyway and one with a regreaseable bronze bushing.
Gearmotor/ Reducers are TEFC 230/460 volts, 3 Phase, & 60 Hz. Comes with a torque arm and factory filled with oil.
Safety equipment includes: side and bottom guarding up to 8’ (2438.4mm) from grade, and a one set (2) E-Stop push buttons.
Finish will be industrial enamel to minimum of 2.5 mils DFT, colored KWS Blue. Other colors are available upon request.